Format:Intel flash descriptor
| Magic | 5A A5 F0 0F at offset 0x10 |
|---|---|
| Extensions | .bin, .rom |
| Endianness | little |
| License | BSD-2-Clause (UEFITool headers) |
| On this wiki | Facts · Code · Notes · Topics |
The 4 KiB descriptor at the start of an Intel x86 SPI flash image (signature 0x0FF0A55A at offset 0x10) that divides the chip into regions: BIOS (UEFI), Management Engine, GbE, platform data and others.
Overview
A full SPI dump of an Intel-chipset PC usually begins with a flash descriptor, followed by regions placed by it. The BIOS region holds the Format:UEFI firmware volume (PI) volumes (scan for _FVH), other regions hold the Management Engine firmware, Ethernet configuration and so on. UEFI-only update files (capsules, vendor installers) normally contain just the BIOS region and no descriptor, see Format:UEFI capsule. This page is recognition level: where the descriptor is and how its region table reads.
Recognition
- Bytes 0x00-0x0F: ReservedVector, 0xFF on x86 (the header comment says it is reserved for an ARM reset vector).
- Bytes 0x10-0x13: Signature 0x0FF0A55A, stored little endian so the file shows
5A A5 F0 0F. - The descriptor region is FLASH_DESCRIPTOR_SIZE 0x1000 bytes.
- The OEM section sits at 0x0F00 (0x100 bytes) and the upper map at 0x0EFC.
Map and regions
After the 20-byte header the descriptor map (FLMAP0-FLMAP3, four dwords) gives base addresses of the other sections as bits [11:4] (shift left by 4 to get the descriptor-relative offset): ComponentBase, RegionBase, MasterBase, PchStrapsBase, ProcStrapsBase. FLMAP3 holds a DescriptorVersion (14 reserved bits, Minor 7 bits, Major 11 bits) that is 0xFFFFFFFF in older firmware; UEFITool knows version 1.0 from Coffee Lake.
The region section is a list of (Base u16, Limit u16) pairs in this order: Descriptor, BIOS, ME, GbE, PDR (platform data), DevExp1, BIOS2 (secondary BIOS), Microcode, EC, DevExp2, IE (Innovation Engine), 10GbE 1, 10GbE 2, Reserved 1, Reserved 2, PTT. Per the header comment a zero limit means the region is absent.
Unverified: the u16 values are bits [27:12] of the flash address, so base address = Base << 12 and the last byte = (Limit << 12) | 0xFFF, a region is absent when Limit < Base (typically Base 0x7FFF, Limit 0). The header says only "upper part of actual UINT32"; test it on a dump by checking that the BIOS region base lands on a firmware volume.
The master section lists read and write access bits per master (BIOS, ME, GbE, later EC); access bit values: 0x01 descriptor, 0x02 BIOS, 0x04 ME, 0x08 GbE, 0x10 PDR, 0x20 EC. Skylake and later use 12-bit read and write masks (the V2 master section).
Analyst notes
- Dumps from a locked machine may be a descriptor-less BIOS region, or a read of only the BIOS region; do not expect the signature in an update file.
- Do not use any of this to defeat flash protections: this page documents the layout only.
- The ME region has its own structures (for example the $CPD signature 0x44504324 and BPDT headers appear in UEFITool's ffs.h); they are not covered here.
Sources: LongSoft/UEFITool common/descriptor.h.
Code & repositories
See the UEFITool entry on Format:UEFI firmware volume (PI).
- https://github.com/LongSoft/UEFITool @
dac91b26733ca21cb204e41614c1b8c81cc50860· license: BSD-2-Clause
UEFITool/UEFIExtract; common/ffs.h and common/descriptor.h read for capsule, volume, FFS and flash descriptor structures
Tested on: source read, not run · checked 2026-10-19; last activity 2026-07-29; Note: the latest release ships binaries; the wiki links only the source, never the binaries